Firmware: 2.10 (released 04/2025)
- Updated parameter names and short descriptions in the Configuration Command Class for improved clarity and consistency.
- Updated parameters 9, 11, and 12 to extend the W, A, and kWh threshold range. See all settings here.
- Added the ability for parameters 9, 11, and 12 to disable reporting based on threshold and report based on frequency for W, A, and kWh. See all settings here.
- Added new parameters 17 (kWh Report Frequency) and 18 (Disable kWh Reports). See all settings here.
Firmware: 2.20 (released 07/2025)
- Optimized Z-Wave reporting behavior: when Basic Set or Binary Set commands are sent from the Z-Wave controller (Lifeline), the device will no longer send redundant report or notification commands back to the controller.
- Adjusted the over-voltage protection threshold in the firmware from 135VAC to 150VAC to minimize false triggers in specific scenarios.
We don’t recommend updating your device unless you’re missing any of the functionality listed in the changelog and the update is absolutely necessary. Before you attempt an update on your device, please read this first:
- Remember to unzip the file after downloading it before using it to update your device. 500 series device files will use the .otz or .hex format while 700/800 series device files will use the .gbl format.
- Always double-check that you’re applying the correct firmware file to the right model and version of your Zooz device. Loading the wrong version to your device may deem it unusable.
- You may need to exclude and re-include the device after the update is complete for best performance. Please consider you may need to rebuild all of your automations and settings for the device.
ZEN05 800LR 2.20 OTA Firmware File here. Update at your own risk.
Get firmware files and learn more about updating your Z-Wave devices here